ACCESSORY FITTING INSTRUCTIONS

JAGUAR

I-PACE

LOADSPACE RAILS

T4K1345

FITTING INSTRUCTION

WARNING
  • Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.
REMOVAL INSTRUCTIONS
1

Open the tailgate.

2

Remove the loadspace floor trim.

3

Remove the left loadspace side trim panel.

For additional information, please refer to the official Workshop Manual. Loadspace Side Trim Panel (501-05)

4

Remove the right loadspace side trim panel.

For additional information, please refer to the official Workshop Manual. Loadspace Side Trim Panel (501-05)

Fitting Instruction
1
NOTE
  • The following steps show the right loadspace side trim panel. Procedure for the left loadspace side trim panel is the same.

 

2

Remove the 2 supports on the underside of the loadspace side trim panel as illustrated. Discard the 2 supports.

3

Draw cut guide lines at both ends of the loadspace side trim panel as illustrated.

4

Measure and then draw 2 marks at 60 mm from the edge of the loadspace side trim panel as illustrated.

5

Using the 2 marks created in step 8, draw a cut guide line along the length of the loadspace side trim panel as illustrated. Join this cut guide line to the 2 cut guide lines drawn in step 7.

6

Using suitable tools, cut a section from the loadspace side trim panel, by following the cut guide lines, as illustrated. Discard the cut section of the loadspace side trim panel.

7

Repeat steps 2 to 6 for the left loadspace side trim panel.

8

Install the modified loadpace side trims panels to the loadspace.

For additional information, please refer to the official Workshop Manual. Loadspace Side Trim Panel (501-05)

9
NOTE
  • Illustrations show the left loadspace rail.

Start the installation of the loadspace rail as illustrated.

  1. Move the loadspace rail so it is positioned against the arrowed edge of the loadspace side trim panel.
  2. Make sure the arrowed tab at the end of the loadspace rail is installed under the edge of the loadspace side trim panel.
10

Move the loadspace rail so it is installed on the loadspace side trim panel as illustrated.

  1. Swing the loadspace rail as illustrated so it is positioned against the loadspace side trim panel.
  2. Make sure the arrowed edge of the loadspace rail is installed under the edge of the loadspace side trim panel.
11

Make sure the end of the loadspace rail is installed above the edge of the loadspace side trim panel as illustrated.

12

Tighten the 2 bolts on the loadspace rail as illustrated.

  • Torque: 24 Nm
13

Repeat steps 9 to 12 for the right loadspace rail.

14

Install the loadspace floor trim.

15

Adjust the sliding D-loop anchor points as required.

16

Close the tailgate.