ACCESSORY FITTING INSTRUCTIONS

JAGUAR

I-PACE

LOADSPACE PARTITION NET

T4K1153

FITTING INSTRUCTION

WARNING
  • Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.
CAUTION
  • Make sure to protect the vehicle paintwork and trim.
WARNING
  • Please read the instructions carefully to prevent damage to the vehicle headliner system.
  • The soft cargo barrier may get damaged or stuck if the instructions are not followed correctly.
NOTE
  • The loadspace upper divider can only be installed to vehicles equipped with the applicable headliner.
Fitting Instruction
NOTE
  • The soft cargo barrier can be installed when the loadspace is configured with the sliding D-loop anchor points or the fixed D-loop anchor points.
2

Open the tailgate.

3
NOTE
  • Store the blanking cap in a safe place.

Remove the blanking cap from the headliner receptacle on the left side of the vehicle. Repeat step for the right side.

4
NOTE
  • Check the orientation of the soft cargo barrier. The logo on the soft cargo barrier must be visible when standing at the rear of the vehicle and looking into the loadspace.

Install the soft cargo barrier into the vehicle loadspace.

5

Secure the soft cargo barrier to the headliner receptacle on the left side of the vehicle as illustrated. Repeat steps for the right side.

  1. Carefully raise the soft cargo barrier pin through the large slot in the headliner receptacle bracket.
  2. Move the soft cargo barrier pin into the small slot in the headliner receptacle bracket.
6

If the fixed D-loop anchor points are installed:

  • Install and secure the soft cargo barrier strap through the D-loop anchor point on the left side of the vehicle as illustrated.
  • Repeat step for the right side of the vehicle.
7

If the sliding D-loop anchor points are installed:

  • Make sure the sliding D-loop anchor points are positioned at the end of the rail nearest the soft cargo barrier.
  • Install and secure the soft cargo barrier strap through the D-loop anchor point on the left side of the vehicle as illustrated.
  • Repeat steps for the right side of the vehicle.
8

Make sure the soft cargo barrier and all fasteners have a safe and correct installation. The straps should be tight and straight.

9

Close the tailgate.