ACCESSORY FITTING INSTRUCTIONS

JAGUAR

I-PACE

DOCKING STATION - IPHONE

J9C3880

FITTING INSTRUCTION

WARNING
  • Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.
Fitting Instruction
1

Remove the cup holder assembly cover.

2

Pull the release lever and release the cup holder assembly.

3

Drill a pilot hole through the complete cup holder assembly in the location illustrated.

4

Remove the 3 torx screws securing the cup holder assembly.

5
NOTE
  • Take care to not dislodge the lever mechanism springs as arrowed.

Split the cup holder assembly.

6
NOTE
  • Use the pilot hole as a center point.

Cut a hole using a suitable cutter.

7
NOTE
  • Use pilot hole as centre point.

 

8

Feed connector end of (A) through both holes drilled in both cup holder sections.

9
NOTE
  • Make sure the grommet is seated correctly as shown.

Secure the grommet to the hole in the lower section.

10
NOTE
  • Take care to position the lever mechanism correctly with the top section.

Connect both sections.

11

 

12
NOTE
  • Make sure the slot in the pad has sufficient clearance of the universal serial bus (USB) lead (A).

Install the pad onto the cup holder.

  1. Remove the adhesive backing.
  2. Carefully position the pad (B).
13

Install the docking station (A) in to the cup holder.

  1. Remove the adhesive backing from the top face of part (B).
  2. Apply pressure to the docking station (A) to make sure full adhesion to the pad (B).
14

Install cup holder into the floor console.

15

Plug in the docking station USB lead to one of the floor console USB slots.

16

Swivel the docking station iPhone back support into the storage position.

17

Install the cup holder assembly cover.