ACCESSORY FITTING INSTRUCTIONS

E-PACE

JAGUAR

E-PACE

DOCKING STATION - IPHONE

J9C3880

FITTING INSTRUCTION

WARNING

Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.

NOTE

Right Hand Drive (RHD) shown, Left Hand Drive (LHD) similar.

1

2

3

Drill a pilot hole through the complete cup holder assembly.

4

5

NOTE

Take care to not dislodge the lever mechanism springs as arrowed.

Split the cup holder assembly.

6

NOTE

Use pilot hole as centre point.

7

NOTE

Use pilot hole as centre point.

8

Feed connector end of (A) through both holes drilled in both cup holder sections.

9

NOTE

Make sure the grommet is seated correctly as shown.

Secure the grommet to the hole in the lower section.

10

NOTE

Take care to position the lever mechanism correctly with the top section.

Connect both sections.

11

12

Install the pad onto the cup holder.

13

Install the docking station (A).

14

15

Plug in the docking station USB lead to one of the rear console USB slots.

16

17

18

Check the operation of the docking station.