ACCESSORY FITTING INSTRUCTIONS

JAGUAR

I-PACE

ROOF SUNSHADE

T4K11558

FITTING INSTRUCTION

WARNING
  • Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.
Fitting Instruction
1

Observe the guide marks on roof sunshades (A) and (B). The guide marks will assist the installation of the clips.

2
NOTE
  • Use the guide marks on the roof sunshade (A) to make sure the clips are correctly positioned.

Install clips (C) and (D) to the roof sunshade (A) as illustrated.

  • There are 3 clips (C). The clips (C) should be attached to roof sunshade (A) as illustrated.
  • There are 5 clips (D). The clips (D) should be attached to roof sunshade (A) as illustrated.
3

Make sure the pull tabs are on the opposite side of the roof sunshade to the clips as illustrated.

4
NOTE
  • Use the guide marks on the roof sunshade (B) to make sure the clips are correctly positioned.

Install 5 clips (D) to the roof sunshade (B) as illustrated.

5

Make sure the pull tabs are on the opposite side of the roof sunshade to the clips as illustrated.

6
CAUTION
  • Take care not to damage the interior trim and the glass with the clips.
NOTE
  • The roof sunshade (A) must be installed in the correct orientation. The pull tabs must be accessible.
  • The recommended way for installing the roof sunshades is by sitting in the second row seat.

Install the roof sunshade (A) to the front section of the fixed glass roof as illustrated.

  1. Slide the roof sunshade (A) forward so the 3 clips (D) slide between the glass and the headliner.
  2. Position the roof sunshade (A) against the fixed glass roof.
7
CAUTION
  • Take care not to damage the interior trim and the glass with the clips.

Install the roof sunshade (A) to the front section of the fixed glass roof as illustrated.

  1. Pull the tabs on the side of the roof sunshade to temporarily deform the blind.
  2. This will allow the 2 clips (D) to be pushed into the groove in the interior trim around the fixed glass roof.
8
CAUTION
  • Take care not to damage the interior trim and the glass with the clips.
NOTE
  • The roof sunshade (B) must be installed in the correct orientation. The pull tabs must be accessible.
  • The recommended way for installing the roof sunshades is by sitting in the second row seat.

Install the roof sunshade (B) to the rear section of the fixed glass roof as illustrated.

  1. Slide the roof sunshade (B) backwards so the 3 clips (D) slide between the glass and the headliner.
  2. Position the roof sunshade (B) against the fixed glass roof.
9
CAUTION
  • Take care not to damage the interior trim and the glass with the clips.

Install the roof sunshade (B) to the rear section of the fixed glass roof as illustrated.

  1. Pull the tabs on the side of the roof sunshade (B) to temporarily deform the blind.
  2. This will allow the 2 clips (D) to be pushed into the groove in the interior trim around the fixed glass roof.
10

Make sure all the clips (D) are correctly installed as illustrated.

11

Join roof sunshade (A) and roof sunshade (B) together using the 3 clips (C) as illustrated.

12

Smooth the material of roof sunshade (A) and roof sunshade (B) using the palm of your hand.

13

Check all the edges of the roof sunshades (A) and (B) to make sure the installation is correct.

REMOVAL INSTRUCTIONS
1

To remove the roof sunshades (A) and (B).

  • Release roof sunshade (B) from the 3 clips (C) located between the 2 roof sunshades (A) and (B).
  • Pull down on the tabs located on each side of the roof sunshades (A) and (B) to remove the roof sunshades.
  • Make sure the 10 clips (D) are still located on the roof sunshades (A) and (B) after removal.