ACCESSORY FITTING INSTRUCTIONS

JAGUAR

I-PACE

CLICK & GO SYSTEM BASE UNIT

J9C2168

FITTING INSTRUCTION

WARNING
  • Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.
  • Head restraints are designed to support the head, not the back of the neck. The head restraint must be positioned correctly to restrain rearward movement of the head in a collision or sudden stop. While stationary, adjust the head restraint so that the top of the head restraint is the same height as the top of the seat occupant's head. An incorrectly adjusted head restraint increases the risk of death or serious injury in the event of a collision.
  • Never adjust the head restraints while the vehicle is in motion.
NOTE
  • You do not require the click and go base unit if you have front seats fitted with the intergrated base unit, as illustrated.
Fitting Instruction
1

Lift the head restraint.

2

Position the click & go base unit.

3

 Install the click & go base unit.

  1. Depress the button.
  2. Compress the click & go base unit.
  3. Push the click & go base unit into position.
4

 Adjust the click & go base unit.

  1. Pull apart the click & go base unit.
  2. Push the click & go base unit down.
5

Install the retaining clips.

6

Push the retaining clips fully into position.

REMOVAL INSTRUCTIONS
1
NOTE
  • Store the clip removal tool (C) in the glovebox when not in use.

Remove the click and go base unit clips.

  1. Insert the removal tool (C) as illustrated
  2. Pull the tool outwards to remove the clip.
2

 Release the click & go base unit.

  1. Depress the button.
  2. Compress the click & go base unit.
3

Remove the click and go base unit

  1. Push the click and go base unit free.
  2. Pull the click and go base unit from the head restraint as illustrated.