ACCESSORY FITTING INSTRUCTIONS

JAGUAR

I-PACE

FRONT GRILLE SURROUND

T4K5669

FITTING INSTRUCTION

WARNING
  • Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.
REMOVAL INSTRUCTIONS
1

Remove front bumper cover  

For additional information, please refer to the official Workshop Manual. Front Bumper (501-19)

2

Disconnect the all the applicable connectors attached to the grille electrical components.

3

Release the electrical harness clips from the grille.

4

Release foam packing from the bumper.

  1. Release 2 clips, as illustrated.
5

Disconnect the 2 inner parking distance sensor connectors.

  1. Pull out the connector release tag.
  2. Carefully release the connector from the parking distance sensor.
6

Release washer hose from the 6 grille clips.

7

Remove the 9 inner grille screws from the inner grille.

8
CAUTION
  • Take care not to damage clips when releasing.
  • Take care not to damage the front bumper harness when moving the grille aside.

Release the inner grille and move aside.

  1. Release the 6 clips as illustrated.
9

Remove the outer grille.

  1. Release the 6 clips as illustrated.
10

Remove the 6 upper cowl screws.

11

Release the 8 grille surround clips and remove the grille surround.

Fitting Instruction
1
CAUTION
  • Take care when aligning clips to the bumper.

Install the Carbon Fiber Grille Surround (A) making sure 8 clips are located correctly.

2

Install upper cowl.

  1. Install and tighten the 6 screws.
    1. Torque: 3Nm.
3

Instal the outer Grille.

  1. Make sure the 6 clips are located correctly.
4

Install inner grille.

  1. Make sure the 6 clips are located correctly.
    1. 2. Install and tighten the 9 screws.
5

Install washer hose to the grille making sure the hose is located in the 6 grille clips.

6

Connect the 2 inner parking distance sensor connectors.

7

Install the foam packing to the bumper.

  1. Make sure the 2 clips have located correctly.
8

Install the connectors and harness clips to the inner grille.

9

Install Front Bumper Cover.

For additional information, please refer to the official Workshop Manual. Specifications (501-08 Exterior Trim and Ornamentation)