ACCESSORY FITTING INSTRUCTIONS

JAGUAR

E-PACE

DOCKING STATION - IPHONE

J9C3880

FITTING INSTRUCTION

WARNING
  • Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.
NOTE
  • Right Hand Drive (RHD) shown, Left Hand Drive (LHD) similar.
Fitting Instruction
1

Open arm rest and remove cup holder assembly.

2

Drill a pilot hole through the complete cup holder assembly.

3

Remove (x1) fixing.

4
NOTE
  • Take care to not dislodge the lever mechanism springs as arrowed.

Split the cup holder assembly.

5
NOTE
  • Use pilot hole as centre point.

Drill a 20mm hole.

6
NOTE
  • Use pilot hole as centre point.

Drill a 20mm hole.

7

Feed connector end of (A) through both holes drilled in both cup holder sections.

8
NOTE
  • Make sure the grommet is seated correctly as shown.

Secure the grommet to the hole in the lower section.

9
NOTE
  • Take care to position the lever mechanism correctly with the top section.

Connect both sections.

10

Install (x1) fixing.

11

Install the pad onto the cup holder.

12

Install the docking station (A).

13

Install cup holder with charger in place.

14

Plug in the docking station USB lead to one of the rear console USB slots.

15

Check the operation of the docking station.

16

When not in use, you can fold down the docking station back to protect the charging port.